Hi friends.
I’ve installed a PicoFly successfully in the past, but I just made a careless mistake at the very end of this install and seem to have bricked the device.
After confirming the chip worked successfully and even loading a payload, I went to close it up and my 3.3V connection popped off. I soldered it back on then reconnected the battery and powered on the Switch, only to get a black screen. After taking a closer look, I realized I had bridged the capacitor before powering on.
I removed the 3.3V and GND wires, leaving the rest of the modchip wires installed, and now the device boots to a blue screen.
imgur dot com/a/waoKXmC
This is the capacitor that I bridged; the default 3.3V hookup in the PicoFly guide. What’s the damage? Any chance I can save the device? Thanks in advance.