Nintendo 2ds XL replacing motherboard

Good Evening.

I was working on my son’s 2ds XL and I encountered a problem. On placing a ribbon cable the latch would not lift on the upper center. I tried to get in the thin ribbon the best way I could but then the latch came off. Is there any way to keep the ribbon placed there with the missing latch. Not to confuse anyone but the ribbon goes to a thin gray port with a tiny latch off center on the upper part of the motherboard.

Many thanks in advance.

Think that is the digitizer ribbon. If the clip didn’t break it is possible to put them back on. Otherwise you may need to get the connector replaced.
I haven’t had much luck getting a good connection with other methods.