Nintendo switch capacitor short near MAX77620H

Nintendo Questions Nintendo Switch
1

Hello everyone!
Its my first time on this website and im very new to repairing things. Right now im trying to repair my nintendo switch v2. I think there might be a short on the two capacitors near the MAX77620H chip (you can see it in red on the picture) because when I put my multimeter in continuity mode, with the black probe on ground and the red one on each capacitor pin, both pins beep for those two capacitors.

I just wanted to ask, could this be a short, or is it normal? Thanks!

Link to the image : ibb. co/LhPVjYnM (i have an error putting the link, just remove the space)

2

around 20 to 40ohm resistance to ground is normal for a v2 switch on that 1.0v rail. What’s your resistance reading?

3

Do i need to unsolder it before testing it ?

4

You can measure resistance to ground without desolder anything, just measure it bare board(no charger or battery)

5

It shows 41.3 i think its good, idk i wanna test everything to see if it works i there any map of the board with every value or not ?