Nintendo Switch Lite - Repair Advice -

[rikabi]

@Severence

biggest, flux heavily, touch bridge then dab tip to clean in wire ball, clean rinse repeat with flux until the majority has gone, flux it up again and then you could just hit it with the hot air again and they should fall back into place.

Alternatively, You can set your hot air to about 200c and hover it over this area while your clearing the bridges with your iron, i suspect your iron/tip is struggling with the thermal mass and the hot air will help

Thanks finally got it off after a combination of these two methods plus moving one the caps off off its pad to clean.

It’s a bit of a mess but no bridge. Also took new readings and ready to take off last ic off.