Hey guys, I have recently tried to replace p13usb since it’s the only short on the board (i was getting 0.2 Amp charging then dead). I have accidentally ripped off the pads ( Circled in Red), Is there anywhere I can connect back the trace with a jumper wire? I have also knocked out one of the resist…

Thanks for the reply. I’ll order some soon once I have capacitor values too. Want to confirm the capacitor right bottom side are 100nf ?

I think they are 100 pf instead

100nf next to the big 10uf cap, same as the one next to 4.7k resistor bottom right

Would you be able to label it on a picture ? Thanks again . And do you have any idea about the traces ?

Thanks my man. You are a life saver. Do you know if this is associated with the 0.2 amp draw then 0 amp?

not sure, I normally dont measure amp when short exist. But I do find often case 10uf bottom cap area short due to pi3 chip bad. Or like my pic shown, blown trace/chip from top right choke filter

Thanks again, that was my though process when my 10uF was shorted. I try to replace the p13usb chip. if my trace is fully destroyed. Could i connect the jumper wire to the correct side the resistor (the red line in your picture)

Ripped up pad near p13usb

Nintendo Questions Nintendo Switch

jkyoho December 31, 2020, 3:42pm 2

1% or 5%, does not matter

Advice on replacing a ripped track and find missing capacitor value around the