The pins are in immaculate condition. No bends there.
As far as the fuse resistance with the 200M (couldn’t go lower) ohm setting selected I get 1.56M ohms on both sides with black probe on ground. I do get continuity through the fuse.
The inductor above the PMIC, to the right, matches the other 1V8 components resistances so I assume that inductor is apart of the 1V8PDR rail. Oddly enough, the inductor just to the left of it doesn’t even give off a DMM value at the 200 ohm setting.
Also, is this cap circled with purple, top left, linked to 1V8?